INES Mapper 015: Difference between revisions
Rainwarrior (talk | contribs) m (→See also: Dish > Disch) |
(→Control ($8000-$FFFF): There appears to be adequate confirmation that 8K mode at power-up does not result in booting, but 32K does) |
||
| Line 63: | Line 63: | ||
The result when b=1 outside of 8K bank mode is not specified. | The result when b=1 outside of 8K bank mode is not specified. | ||
Some emulators (fceux, virtuanesex) are XORing the b (8KB half) bit frequently instead of ORing or ignoring. It is unclear what effects this would have. | |||
The power-up state has bank mode and bank set to 0, resulting in the first 32K bank mapped in. | |||
Mirroring at power-up is not specified, but it is likely vertical given that all other state bits are 0. | |||
The unlicensed chinese WXN game "Bio Hazard" which uses this mapper freezes in the same way in fceux, fceu-mm, nestopia, bizhawk, and virtuanesx (maybe?) and so the game is probably buggy. | The unlicensed chinese WXN game "Bio Hazard" which uses this mapper freezes in the same way in fceux, fceu-mm, nestopia, bizhawk, and virtuanesx (maybe?) and so the game is probably buggy. | ||
Revision as of 15:30, 9 June 2016
The iNES format assigns iNES Mapper 015 as the mapper used in 100-in-1 Contra Function 16, the first pirate multicart to be emulated.
The mapper allows multiple NROM or BNROM games plus one UNROM game to be used with very little modification. A few games originally released on a CNROM compatible board (such as two variants of Tetris) showed up on the cart; these were ripped to NROM by tossing out all 8 KB CHR banks except the one used for gameplay.
Overview
- PRG ROM size: Up to 512 KB
- PRG ROM bank size: 8 KB, 16 KB, or 32 KB
- PRG RAM: 8 KB
- CHR capacity: 8 KB RAM
- CHR bank size: None
- Nametable mirroring: Controlled by mapper
- Subject to bus conflicts: Unknown
Banks
There is one switchable bank. How this is mapped into depends on the current bank mode (see Registers below).
Bank mode 0 ( 32K )
- CPU $8000-$BFFF: Bank B
- CPU $C000-$FFFF: Bank (B bitwise ORed with 1)
If bit 0 of B equals 1, then the 16K and 32K modes are identical.
Bank mode 1 ( 128K )
- CPU $8000-$BFFF: Switchable 16 KB bank B
- CPU $C000-$DFFF: Fixed to last bank in the cart
This mode uses the same configuration as UNROM.
Bank mode 2 ( 8K )
- CPU $8000-$9FFF: Sub-bank b of 16 KB PRG ROM bank B
- CPU $A000-$FFFF: Mirrors of $8000-$9FFF
Bank mode 3 ( 16K )
- CPU $8000-$BFFF: 16 KB bank B
- CPU $C000-$FFFF: Mirror of $8000-$BFFF
Registers
Control ($8000-$FFFF)
This is a 10-bit register. The upper 2 bits of the value are set from address lines A1-A0.
15 bit 8 7 bit 0 Address bus
---- ---- ---- ----
1xxx xxxx xxxx xxSS
| ||
| ++- Select PRG ROM bank mode
| 0: 32K; 1: 128K (UNROM style); 2: 8K; 3: 16K
+------------------- Always 1
7 bit 0 Data bus
---- ----
bMBB BBBB
|||| ||||
||++-++++- Select 16 KB PRG ROM bank
|+-------- Select nametable mirroring mode (0=vertical; 1=horizontal)
+--------- Select 8 KB half of 16 KB PRG ROM bank
(should be 0 except in 8K bank mode)
The result when b=1 outside of 8K bank mode is not specified. Some emulators (fceux, virtuanesex) are XORing the b (8KB half) bit frequently instead of ORing or ignoring. It is unclear what effects this would have.
The power-up state has bank mode and bank set to 0, resulting in the first 32K bank mapped in. Mirroring at power-up is not specified, but it is likely vertical given that all other state bits are 0.
The unlicensed chinese WXN game "Bio Hazard" which uses this mapper freezes in the same way in fceux, fceu-mm, nestopia, bizhawk, and virtuanesx (maybe?) and so the game is probably buggy.
See also
- NES Mapper List by Disch
- Comprehensive NES Mapper Document by \Firebug\
