APU Pulse

Each of the two NES APU pulse (square) wave channels generate a pulse wave with variable duty.

Each pulse channel contains the following: envelope generator, sweep unit, timer, 8-step sequencer, length counter. Note: the addresses below are write-only!

                     Sweep -----> Timer
                       |            |
                       |            |
                       |            v 
                       |        Sequencer   Length Counter
                       |            |             |
                       |            |             |
                       v            v             v
    Envelope -------> Gate -----> Gate -------> Gate --->(to mixer)

Address	Bitfield	Description
$4000	DDlc.vvvv	Pulse 1 Duty cycle, length counter halt, constant volume/envelope flag, and volume/envelope divider period
$4004	DDlc.vvvv	Pulse 2 Duty cycle, length counter halt, constant volume/envelope flag, and volume/envelope divider period
Side effects		The duty cycle is changed (see table below), but the sequencer's current position isn't affected.
$4001	EPPP.NSSS	See APU Sweep
$4005	EPPP.NSSS	See APU Sweep
$4002	LLLL.LLLL	Pulse 1 timer Low 8 bits
$4006	LLLL.LLLL	Pulse 2 timer Low 8 bits
$4003	llll.lHHH	Pulse 1 length counter load and timer High 3 bits
$4007	llll.lHHH	Pulse 2 length counter load and timer High 3 bits
Side effects		The sequencer is immediately restarted at the first value of the current sequence. The envelope is also restarted. The period divider is not reset.[1]

Duty Cycle Sequences

Duty	Waveform sequence
0	0 1 0 0 0 0 0 0 (12.5%)
1	0 1 1 0 0 0 0 0 (25%)
2	0 1 1 1 1 0 0 0 (50%)
3	1 0 0 1 1 1 1 1 (25% negated)

The reason for these odd sequences is that the sequence counter is initialized to zero but counts downward rather than upward

The sequencer is clocked by an 11-bit timer. Given the timer value t = HHHLLLLLLLL formed by timer high and timer low, this timer is updated every APU cycle (i.e., every second CPU cycle), and counts t, t-1, ..., 0, t, t-1, ..., clocking the waveform generator when it goes from 0 to t. Since the period of the timer is t+1 APU cycles and the sequencer has 8 steps, the period of the waveform is 8*(t+1) APU cycles, or equivalently 16*(t+1) CPU cycles.

Hence

• f_pulse = f_CPU/(16*(t+1)) (where f_CPU is 1.789773 MHz for NTSC, 1.662607 MHz for PAL, and 1.773448 MHz for Dendy)
• t = f_CPU/(16*f_pulse) - 1

A period of t < 8, either set explicitly or via a sweep period update, silences the corresponding pulse channel. The highest frequency a pulse channel can output is hence about 12.4 kHz for NTSC. (TODO: PAL behavior?)

The mixer receives the current envelope volume except when

• The sequencer output is zero, or
• overflow from the sweep unit's adder is silencing the channel, or
• the length counter is zero, or
• the timer has a value less than eight.

The behavior of the two pulse channels differs only in the effect of the negate mode of their sweep units.

Notice that a few Famiclone units have swapped APU duty cycles, as 12.5, 50, 25 and 25 negated instead.