INES Mapper 119

iNES Mapper 119 is used to designate the TQROM board, which uses the Nintendo MMC3 like other TxROM boards but uses the CHR bank number in such a way so as to allow both CHR ROM and CHR RAM to be used simultaneously.

Registers

See MMC3

Bank data ($8001-$9FFF, odd)

Bit 6 of the CHR bank number is used to switch between the CHR ROM chip and the CHR RAM chip.

7  bit  0
---- ----
xCDD DDDD
 ||| ||||
 |++-++++- New bank value, based on last value written to Bank select register
 |         0: Select 2 KB CHR bank at PPU $0000-$07FF (or $1000-$17FF);
 |         1: Select 2 KB CHR bank at PPU $0800-$0FFF (or $1800-$1FFF);
 |         2: Select 1 KB CHR bank at PPU $1000-$13FF (or $0000-$03FF);
 |         3: Select 1 KB CHR bank at PPU $1400-$17FF (or $0400-$07FF);
 |         4: Select 1 KB CHR bank at PPU $1800-$1BFF (or $0800-$0BFF);
 |         5: Select 1 KB CHR bank at PPU $1C00-$1FFF (or $0C00-$0FFF);
 |         6, 7: As standard MMC3
 +-------- Chip select (for CHR banks)
           0: Select CHR ROM; 1: Select CHR RAM

Nintendo could have used bit 7 instead of bit 6, allowing 128 KiB of CHR ROM instead of 64 KiB. However, using bit 7 would have precluded a hypothetical "TQSROM" board combining TQROM-style ROM/RAM mixing with TLSROM-style single-screen mirroring. Rare developed both games on this board, and Rare was also a big fan of single-screen mirroring on the AxROM boards.

Hardware

A 74HC32 IC controls the CHR ROM's enable line. PPU A13 is ORed with CHR A16 in order to create a /CE signal for the CHR ROM. CHR A16 also directly connects the positice CE pin on the 6264 RAM.

For some totally unknown reason (board space ?) official TQROM boards doesn't allow PRG ROMs greater than 128 KB. However, a third party board could expand this mapper up to 512 KB of PRG ROM, like any other MMC3 boards.

References

• NES-TQROM by Kevin Horton