|
|
| (2 intermediate revisions by one other user not shown) |
| Line 1: |
Line 1: |
| '''TQROM''' denotes Nintendo's NES-TQROM and [[Famicom|HVC]]-TQROM cartridge boards, which use the [[MMC3|Nintendo MMC3]] ASIC mapper.
| | #REDIRECT [[INES Mapper 119]] |
| This [[rare]] board, used only by ''Pinbot'' and ''High Speed'', is one of the few that have both CHR ROM and CHR RAM on the same board.
| | [[Category:Nintendo licensed mappers]] |
| The [[iNES]] format assigns [[iNES Mapper 119|mapper 119]] to this board.
| |
| | |
| == Overview ==
| |
| * PRG ROM size: 128 KB (DIP-28 Nintendo pinout)
| |
| * PRG ROM bank size: 8 KB
| |
| * PRG RAM: Up to 8 KB
| |
| * CHR capacity: 32 or 64 KB ROM (DIP-28 standard pinout) and 8 KB RAM [[Category:Mappers with CHR RAM]]
| |
| * CHR bank size: 1 KB and 2 KB
| |
| * Nametable [[mirroring]]: Controlled by mapper
| |
| * Subject to [[bus conflict]]s: No
| |
| | |
| == Registers ==
| |
| See [[MM3]]
| |
| | |
| === Bank data ($8001-$9FFF, odd) ===
| |
| Bit 6 of the CHR bank number is used to switch between the CHR ROM chip and the CHR RAM chip.
| |
| | |
| 7 bit 0
| |
| ---- ----
| |
| xCDD DDDD
| |
| ||| ||||
| |
| |++-++++- New bank value, based on last value written to Bank select register
| |
| | 0: Select 2 KB CHR bank at PPU $0000-$07FF (or $1000-$17FF);
| |
| | 1: Select 2 KB CHR bank at PPU $0800-$0FFF (or $1800-$1FFF);
| |
| | 2: Select 1 KB CHR bank at PPU $1000-$13FF (or $0000-$03FF);
| |
| | 3: Select 1 KB CHR bank at PPU $1400-$17FF (or $0400-$07FF);
| |
| | 4: Select 1 KB CHR bank at PPU $1800-$1BFF (or $0800-$0BFF);
| |
| | 5: Select 1 KB CHR bank at PPU $1C00-$1FFF (or $0C00-$0FFF);
| |
| | 6, 7: As standard MMC3
| |
| +-------- Chip select (for CHR banks)
| |
| 0: Select CHR ROM; 1: Select CHR RAM
| |
| | |
| == Hardware ==
| |
| A [[7432|74HC32]] IC controls the CHR RAM's enable line.
| |
| | |
| == References ==
| |
| *[http://kevtris.org/mappers/mmc3/NES_TQROM.html NES-TQROM] by Kevin Horton
| |
