INES Mapper 015: Difference between revisions
From NESdev Wiki
Jump to navigationJump to search
NewRisingSun (talk | contribs) (Rewrite for conciseness, add write-protection note, clarity on mapper hack use) |
(→Address and Data Latch ($8000-$FFFF, write): register is cleared on soft reset too) |
||
| Line 22: | Line 22: | ||
2: NROM-64 (PRG A13=p) | 2: NROM-64 (PRG A13=p) | ||
3: NROM-128 | 3: NROM-128 | ||
Power-on value: All bits clear | Power-on and reset value: All bits clear | ||
CHR-RAM is write-protected in PRG banking modes 0 and 3, and write-enabled in modes 1 and 2. | CHR-RAM is write-protected in PRG banking modes 0 and 3, and write-enabled in modes 1 and 2. | ||
=Use for mapper hacks= | =Use for mapper hacks= | ||
The only known two cartridges using this mapper are the two listed multicarts. All other known ROM files claiming to use mapper 15 have been identified as being mapper hacks, usually from mappers [[INES Mapper 164|164]] and [[INES Mapper 227|227]]. To run these mapper-hacked games, emulators must not enforce CHR-RAM write-protection even though an actual K-1029 PCB would, and must provide 8 KiB of PRG-RAM at CPU $6000-$7FFF even though an actual K-1029 PCB would not. | The only known two cartridges using this mapper are the two listed multicarts. All other known ROM files claiming to use mapper 15 have been identified as being mapper hacks, usually from mappers [[INES Mapper 164|164]] and [[INES Mapper 227|227]]. To run these mapper-hacked games, emulators must not enforce CHR-RAM write-protection even though an actual K-1029 PCB would, and must provide 8 KiB of PRG-RAM at CPU $6000-$7FFF even though an actual K-1029 PCB would not. | ||
Revision as of 20:35, 2 November 2019
iNES Mapper 015 denotes the K-1029 circuit board, used for the 100-in-1 Contra Function 16 and 168-in-1 New Contra Function 16 multicarts.
Banks
- CPU $8000-$FFFF: Switchable PRG-ROM banks (8/16/32 KiB)
- PPU $0000-$1FFF: Unbanked 8 KiB of CHR-RAM that can be write-protected
- Nametable mirroring: Switchable horizontal/vertical settings
Address and Data Latch ($8000-$FFFF, write)
Mask: $8000
A~FEDC BA98 7654 3210 D~7654 3210
------------------- ---------
1... .... .... ..SS pMPP PPPP
|| ||++-++++- PRG A14..A19
|| |+-------- Nametable mirroring
|| | 0: Vertical
|| | 1: Horizontal
|| +--------- PRG A13 if SS=2, ignored otherwise
++-------------- PRG banking mode
0: NROM-256 (PRG A14=CPU A14)
1: UNROM (PRG A14..16=111 when CPU A14=1)
2: NROM-64 (PRG A13=p)
3: NROM-128
Power-on and reset value: All bits clear
CHR-RAM is write-protected in PRG banking modes 0 and 3, and write-enabled in modes 1 and 2.
Use for mapper hacks
The only known two cartridges using this mapper are the two listed multicarts. All other known ROM files claiming to use mapper 15 have been identified as being mapper hacks, usually from mappers 164 and 227. To run these mapper-hacked games, emulators must not enforce CHR-RAM write-protection even though an actual K-1029 PCB would, and must provide 8 KiB of PRG-RAM at CPU $6000-$7FFF even though an actual K-1029 PCB would not.
See also
- schematic RE'd by krzysiobal
