MMC4

The Nintendo MMC4 is an ASIC mapper, used on the FxROM board set. The iNES format assigns mapper 10 to these boards. The chip first appeared in August 1987.

Overview

• PRG ROM size: 256 KB
• PRG ROM bank size: 16 KB
• PRG RAM: 8 KB + battery
• CHR capacity: 128 KB
• CHR bank size: 4 KB
• Nametable mirroring: Vertical or horizontal, controlled by program
• Subject to bus conflicts: No

Banks

• CPU $6000-$7FFF: 8 KB fixed PRG RAM bank
• CPU $8000-$BFFF: 16 KB switchable PRG ROM bank
• CPU $C000-$FFFF: 16 KB PRG ROM bank, fixed to the last bank
• PPU $0000-$0FFF: Two 4 KB switchable CHR ROM banks
• PPU $1000-$1FFF: Two 4 KB switchable CHR ROM banks

When the PPU reads from specific tiles in the pattern table during rendering, the MMC4 sets a latch that tells it to use a different 4 KB bank number. This has the effect of setting a different bank for all tiles to the right of a given tile.

• PPU reads $0FD0 through $0FDF: latch 0 is set to $FD
• PPU reads $0FE0 through $0FEF: latch 0 is set to $FE
• PPU reads $1FD0 through $1FDF: latch 1 is set to $FD
• PPU reads $1FE0 through $1FEF: latch 1 is set to $FE

Registers

PRG ROM bank select ($A000-$AFFF)

7  bit  0
---- ----
xxxx PPPP
     ||||
     ++++- Select 16 KB PRG ROM bank for CPU $8000-$BFFF

CHR ROM $FD/0000 bank select ($B000-$BFFF)

7  bit  0
---- ----
xxxC CCCC
   | ||||
   +-++++- Select 4 KB CHR ROM bank for PPU $0000-$0FFF
           used when latch 0 = $FD

CHR ROM $FE/0000 bank select ($C000-$CFFF)

7  bit  0
---- ----
xxxC CCCC
   | ||||
   +-++++- Select 4 KB CHR ROM bank for PPU $0000-$0FFF
           used when latch 0 = $FE

CHR ROM $FD/1000 bank select ($D000-$DFFF)

7  bit  0
---- ----
xxxC CCCC
   | ||||
   +-++++- Select 4 KB CHR ROM bank for PPU $1000-$1FFF
           used when latch 1 = $FD

CHR ROM $FE/1000 bank select ($E000-$EFFF)

7  bit  0
---- ----
xxxC CCCC
   | ||||
   +-++++- Select 4 KB CHR ROM bank for PPU $1000-$1FFF
           used when latch 1 = $FE

Mirroring ($F000-$FFFF)

7  bit  0
---- ----
xxxx xxxM
        |
        +- Select nametable mirroring (0: vertical; 1: horizontal)

Hardware

The MMC4 is implemented in a 44-pin TQFP package. Only one revision is known to exist.

Variants

The Nintendo MMC2, used in PxROM boards, is a similar mapper with 8 KB switchable PRG ROM banks, a 24 KB fixed PRG ROM bank, and no PRG RAM.