TQROM

TQROM denotes Nintendo's NES-TQROM and HVC-TQROM cartridge boards, which use the Nintendo MMC3 ASIC mapper. This rare board, used only by Pinbot and High Speed, is one of the few that have both CHR ROM and CHR RAM on the same board. The iNES format assigns mapper 119 to this board.

Overview

• PRG ROM size: 128 KB (DIP-28 Nintendo pinout)
• PRG ROM bank size: 8 KB
• PRG RAM: Up to 8 KB
• CHR capacity: 32 or 64 KB ROM (DIP-28 standard pinout) and 8 KB RAM
• CHR bank size: 1 KB and 2 KB
• Nametable mirroring: Controlled by mapper
• Subject to bus conflicts: No

Registers

See MM3

Bank data ($8001-$9FFF, odd)

Bit 6 of the CHR bank number is used to switch between the CHR ROM chip and the CHR RAM chip.

7  bit  0
---- ----
xCDD DDDD
 ||| ||||
 |++-++++- New bank value, based on last value written to Bank select register
 |         0: Select 2 KB CHR bank at PPU $0000-$07FF (or $1000-$17FF);
 |         1: Select 2 KB CHR bank at PPU $0800-$0FFF (or $1800-$1FFF);
 |         2: Select 1 KB CHR bank at PPU $1000-$13FF (or $0000-$03FF);
 |         3: Select 1 KB CHR bank at PPU $1400-$17FF (or $0400-$07FF);
 |         4: Select 1 KB CHR bank at PPU $1800-$1BFF (or $0800-$0BFF);
 |         5: Select 1 KB CHR bank at PPU $1C00-$1FFF (or $0C00-$0FFF);
 |         6, 7: As standard MMC3
 +-------- Chip select (for CHR banks)
           0: Select CHR ROM; 1: Select CHR RAM

Hardware

A 74HC32 IC controls the CHR RAM's enable line.

References

• NES-TQROM by Kevin Horton