PPU pinout

Pin out

         .--\/--.					 
  R/W -> |01  40| -- +5
   D0 <> |02  39| -> ALE
   D1 <> |03  38| <> AD0
   D2 <> |04  37| <> AD1
   D3 <> |05  36| <> AD2
   D4 <> |06  35| <> AD3
   D5 <> |07  34| <> AD4
   D6 <> |08  33| <> AD5
   D7 <> |09  32| <> AD6
   A2 -> |10  31| <> AD7
   A1 -> |11  30| -> A8
   A0 -> |12  29| -> A9
  /CS -> |13  28| -> A10
 EXT0 <> |14  27| -> A11
 EXT1 <> |15  26| -> A12
 EXT2 <> |16  25| -> A13
 EXT3 <> |17  24| -> /RD
  CLK -> |18  23| -> /WR
 /INT <- |19  22| <- /RST
  GND -- |20  21| -> VOUT
         `------'

Signal description

• R/W, Dx, A0, A1, A2 are the signals from the CPU
• /CS is generated by the 74139 on the mainboard to map the PPU in the range from $2000 to $3FFF
• EXTx allows the combination of two PPUs - setting the "slave" bit in the "control" register causes the PPU to output palette indices to these pins, and clearing said bit causes it to instead read indices from these pins (and use them to select the background color).
• CLK is the 21.47727 MHz (NTSC) or 26.6017 MHz (PAL) clock input. It is doubled for the color generator (and then divided by 12 to get the colorburst frequency) and also divided by 4 (NTSC) or 5 (PAL) for the pixel and memory clocks.
• /INT is connected to the CPU's /NMI pin. (In a dual-PPU arrangement, the master /INT is also connected to the slave's /RST input)
• ALE tells the PPU to latch the ADx bus to generate the lower 8 bits of the PPU's address bus
• ADx is the PPU's data bus, multiplexed with the lower 8 bits of the PPU's address bus.
• A8..A13 are the top 6 bits of the PPU's address bus.
• /RD and /WR specify that the PPU is reading or writing to its private memory
• /RST resets certain parts of the chip to their initial power-on state: the clock divider, video phase generator, scanline/pixel counters, and the even/odd frame toggle. It also keeps several registers zeroed out for a full frame: PPUCTRL ($2000), PPUMASK ($2001), PPUSCROLL ($2005 - the VRAM address latch "T", fine X scroll, and the H/V toggle), and the VRAM read buffer. It is used in the NES to clear the screen when the console is reset either by the button or the CIC, and in a dual-PPU system it can be used to genlock the two PPUs together.
• VOUT is the shifted analog video output