INES Mapper 218
iNES Mapper 218 is used by the homebrew Magic Floor game. The cartridge contains only one single PRG-ROM chip (and a CIC, if required).
There's no CHR-ROM or CHR-RAM. Instead, the console's internal 2Kbyte Name Table RAM is mapped as CHR-RAM. The 2K RAM is permanently selected (/VCS wired to GND), and can be used in four modes by wiring VA10 to one of the PPU.A10..A13 address lines:
| VA10 connection | Effect on nametables | iNES Flags 6 | UNIF "MIRR" bit 7-0 |
|---|---|---|---|
| PPU.A10 | Two-Screen, Vertical Mirroring | $A1 (0001) | $01 |
| PPU.A11 | Two-Screen, Horizontal Mirroring | $A0 (0000) | $00 |
| PPU.A12 | One-Screen, BLK0 | $A8 (1000) | $02 |
| PPU.A13 | One-Screen, BLK1 | $A9 (1001) | $03 |
Note: Bit 3 in Byte 6 of iNES header would be usually Four-Screen flag, but, for this mapper it is used as One-Screen flag.
The VA10 connection does, of course, also affect the CHR-RAM mapping at 0000h-1FFFh. BLK1 would be the most common case (1K NT plus 1K CHR-RAM). BLK0 would allow to swap CHR RAM via Port 2000h.Bit3-4. Two-Screen would allow to use two NTs (and to squeeze CHR data into unused NT areas). Two-Screen would also allow to use 2K OBJ tiles (when leaving BG unused).
Note: 1K CHR-RAM allows to use as much as 64 tiles of 2bpp (or, with suitable color attributes, 128 monochrome tiles of 1bpp).
Also not that with if reads/writes to mirrored addresses are avoided, software for this mapper can also be made compatible with AxROM ($A8,$A9), BxROM ($A0,A1) or NROM + CHR-RAM, or other suitable mappers. Magic Floor itself is well behaved enough to be emulated as AxROM or NROM + CHR-RAM with vertical mirroring.
It has been used in two games, and one test ROM:
- Magic Floor ($A8)
- Starfight ($A8)
- OAM corruption stress test ROM ($A0)
