AxROM

The generic designation AxROM refers to Nintendo cartridge boards NES-AMROM, NES-ANROM, NES-AN1ROM, NES-AOROM, their HVC counterparts, and clone boards. Most games developed by Rare Ltd. used an AxROM series board. The iNES format assigns mapper 7 to AxROM.

The following AxROM boards are known to exist:

Board	PRG ROM	Bus conflicts
AMROM	128 KB	Yes
ANROM	128 KB	No
AN1ROM	64 KB	No
AOROM	128, 256 KB	Yes (by default)

Overview

• PRG ROM size: up to 256 KB
• PRG ROM bank size: 32 KB
• PRG RAM: None
• CHR capacity: 8 KB RAM
• CHR bank size: Not bankswitched
• Nametable mirroring: Single-screen, mapper-selectable
• Subject to bus conflicts: AMROM/AOROM only

Banks

• CPU $8000-$FFFF: 32 KB switchable PRG ROM bank

Solder pad config

No solder pad config is needed on the AxROM board family.

Registers

Bank select ($8000-$FFFF)

7  bit  0
---- ----
xxxM xPPP
   |  |||
   |  +++- Select 32 KB PRG ROM bank for CPU $8000-$FFFF
   +------ Select 1 KB VRAM page for all 4 nametables

Hardware

The AxROM boards contain a 74HC161 binary counter used as a quad D latch (4-bit register). The ANROM and AN1ROM boards also contains a 74HC02 which is used to disable the PRG ROM during writes, thus avoiding bus conflicts.

Various notes

On the AOROM board, special mask ROMs with an additional positive CE on pin 2 (which is connected to PRG R/W) can be used to prevent bus conflicts without an additional chip. A few 128 KB games used AOROM instead of ANROM because this might sometimes be cheaper than a 74HC02 depending on production quantities.

Variants

The only difference between AMROM and BNROM is the mirroring configuration.

In theory, it would be possible to implement the bank select register with a 74HC377 octal D latch, allowing up to 512 kilobytes of PRG ROM, but due to mask ROM cost in the NES era, no non-pirate NES cart used this much memory.