|
|
| (63 intermediate revisions by 8 users not shown) |
| Line 1: |
Line 1: |
| [[Category:ASIC mappers]] | | #REDIRECT [[INES Mapper 019]] |
| The '''Namco 106''' and '''Namco 163''' are [[:Category:ASIC mappers|ASIC]] [[MMC|mappers]], assigned to [[INES_Mapper_019 | iNES mapper 19]]. A variant of this mapper with hardwired mirroring is assigned to [[INES_Mapper_210 | iNES mapper 210]].
| | [[Category:Mappers with CHR ROM and CHR RAM]][[Category:Mappers using $4020-$5FFF]][[Category:ASIC mappers]][[Category:Mappers with ROM nametables]][[Category:Mappers with cycle IRQs]][[Category:Mappers with single-screen mirroring]] |
| | |
| == Overview ==
| |
| * PRG ROM size: Up to 512 KB
| |
| * PRG ROM bank size: 8 KB
| |
| * PRG RAM: Up to 8 KB
| |
| * CHR capacity: Up to 256 KB ROM and/or 32 KB RAM simultaneously [[Category:Mappers with CHR RAM]]
| |
| * CHR bank size: 1 KB
| |
| * Nametable [[mirroring]]: Controlled by mapper (Mapper 19), hardwired (Mapper 210)
| |
| * Subject to [[bus conflict]]s: No
| |
| | |
| == Banks ==
| |
| * CPU $6000-$7FFF: 8 KB PRG RAM bank
| |
| * CPU $8000-$9FFF: 8 KB switchable PRG ROM bank
| |
| * CPU $A000-$BFFF: 8 KB switchable PRG ROM bank
| |
| * CPU $C000-$DFFF: 8 KB switchable PRG ROM bank
| |
| * CPU $E000-$FFFF: 8 KB PRG ROM bank, fixed to the last bank
| |
| * PPU $0000-$03FF: 1 KB switchable CHR bank
| |
| * PPU $0400-$07FF: 1 KB switchable CHR bank
| |
| * PPU $0800-$0BFF: 1 KB switchable CHR bank
| |
| * PPU $0C00-$0FFF: 1 KB switchable CHR bank
| |
| * PPU $1000-$13FF: 1 KB switchable CHR bank
| |
| * PPU $1400-$17FF: 1 KB switchable CHR bank
| |
| * PPU $1800-$1BFF: 1 KB switchable CHR bank
| |
| * PPU $1C00-$1FFF: 1 KB switchable CHR bank
| |
| | |
| == Registers ==
| |
| | |
| The n106 has 19 registers within $4800-$FFFF, except $6000-$7FFF which is WRAM. Each register occupies a range of $800 bytes, so $4800-$4FFF all refers to one register, $5000-$57FF all refers to another register, and so on.
| |
| | |
| === Sound Data Port ($4800-$4FFF) r/w ===
| |
| See [[Namco 163 audio]].
| |
| | |
| === IRQ Counter (low) ($5000-$57FF) r/w ===
| |
| 7 bit 0
| |
| ---- ----
| |
| IIII IIII
| |
| |||| ||||
| |
| ++++-++++- Low 8 bits of IRQ counter
| |
| | |
| === IRQ Counter (high) / IRQ Enable ($5800-$5FFF) r/w ===
| |
| 7 bit 0
| |
| ---- ----
| |
| EIII IIII
| |
| |||| ||||
| |
| |+++-++++- High 7 bits of IRQ counter
| |
| +--------- IRQ Enable: (0: disabled; 1: enabled)
| |
| | |
| === CHR Select 1 ($8000-$87FF) w ===
| |
| 7 bit 0
| |
| ---- ----
| |
| CCCC CCCC
| |
| |||| ||||
| |
| ++++-++++- Select 1KB page of CHR-ROM or CHR-RAM at $0000
| |
| '''Note:''' Pages $E0-$FF are CHR-RAM, as long as $E800.6 is set to 0. If $E800.6 is set to 1, then pages $E0-$FF refer to the last $20 pages of CHR-ROM as you'd expect.
| |
| | |
| === CHR Select 2 ($8800-$88FF) w ===
| |
| 7 bit 0
| |
| ---- ----
| |
| CCCC CCCC
| |
| |||| ||||
| |
| ++++-++++- Select 1KB page of CHR-ROM or CHR-RAM at $0400
| |
| '''Note:''' Pages $E0-$FF are CHR-RAM, as long as $E800.6 is set to 0. If $E800.6 is set to 1, then pages $E0-$FF refer to the last $20 pages of CHR-ROM as you'd expect.
| |
| | |
| === CHR Select 3 ($9000-$97FF) w ===
| |
| 7 bit 0
| |
| ---- ----
| |
| CCCC CCCC
| |
| |||| ||||
| |
| ++++-++++- Select 1KB page of CHR-ROM or CHR-RAM at $0800
| |
| '''Note:''' Pages $E0-$FF are CHR-RAM, as long as $E800.6 is set to 0. If $E800.6 is set to 1, then pages $E0-$FF refer to the last $20 pages of CHR-ROM as you'd expect.
| |
| | |
| === CHR Select 4 ($9800-$9FFF) w ===
| |
| 7 bit 0
| |
| ---- ----
| |
| CCCC CCCC
| |
| |||| ||||
| |
| ++++-++++- Select 1KB page of CHR-ROM or CHR-RAM at $0C00
| |
| '''Note:''' Pages $E0-$FF are CHR-RAM, as long as $E800.6 is set to 0. If $E800.6 is set to 1, then pages $E0-$FF refer to the last $20 pages of CHR-ROM as you'd expect.
| |
| | |
| === CHR Select 5 ($A000-$A7FF) w ===
| |
| 7 bit 0
| |
| ---- ----
| |
| CCCC CCCC
| |
| |||| ||||
| |
| ++++-++++- Select 1KB page of CHR-ROM or CHR-RAM at $1000
| |
| '''Note:''' Pages $E0-$FF are CHR-RAM, as long as $E800.7 is set to 0. If $E800.7 is set to 1, then pages $E0-$FF refer to the last $20 pages of CHR-ROM as you'd expect.
| |
| | |
| === CHR Select 6 ($A800-$AFFF) w ===
| |
| 7 bit 0
| |
| ---- ----
| |
| CCCC CCCC
| |
| |||| ||||
| |
| ++++-++++- Select 1KB page of CHR-ROM or CHR-RAM at $1400
| |
| '''Note:''' Pages $E0-$FF are CHR-RAM, as long as $E800.7 is set to 0. If $E800.7 is set to 1, then pages $E0-$FF refer to the last $20 pages of CHR-ROM as you'd expect.
| |
| | |
| === CHR Select 7 ($B000-$B7FF) w ===
| |
| 7 bit 0
| |
| ---- ----
| |
| CCCC CCCC
| |
| |||| ||||
| |
| ++++-++++- Select 1KB page of CHR-ROM or CHR-RAM at $1800
| |
| '''Note:''' Pages $E0-$FF are CHR-RAM, as long as $E800.7 is set to 0. If $E800.7 is set to 1, then pages $E0-$FF refer to the last $20 pages of CHR-ROM as you'd expect.
| |
| | |
| === CHR Select 8 ($B800-$BFFF) w ===
| |
| 7 bit 0
| |
| ---- ----
| |
| CCCC CCCC
| |
| |||| ||||
| |
| ++++-++++- Select 1KB page of CHR-ROM or CHR-RAM at $1C00
| |
| '''Note:''' Pages $E0-$FF are CHR-RAM, as long as $E800.7 is set to 0. If $E800.7 is set to 1, then pages $E0-$FF refer to the last $20 pages of CHR-ROM as you'd expect.
| |
| | |
| === Nametable Select 1 ($C000-$C7FF) w ===
| |
| 7 bit 0
| |
| ---- ----
| |
| NNNN NNNN
| |
| |||| ||||
| |
| ++++-++++- Select nametable at $2000:
| |
| $00-$DF: Use a 1KB page of CHR-ROM as a nametable
| |
| $E0-$FF: Use the NES's internal nametables (even values for A, odd values for B)
| |
| '''Note:''' On mapper 210, this register has no effect.
| |
| | |
| === Nametable Select 2 ($C800-$CFFF) w ===
| |
| 7 bit 0
| |
| ---- ----
| |
| NNNN NNNN
| |
| |||| ||||
| |
| ++++-++++- Select nametable at $2400:
| |
| $00-$DF: Use a 1KB page of CHR-ROM as a nametable
| |
| $E0-$FF: Use the NES's internal nametables (even values for A, odd values for B)
| |
| '''Note:''' On mapper 210, this register has no effect.
| |
| | |
| === Nametable Select 3 ($D000-$D7FF) w ===
| |
| 7 bit 0
| |
| ---- ----
| |
| NNNN NNNN
| |
| |||| ||||
| |
| ++++-++++- Select nametable at $2800:
| |
| $00-$DF: Use a 1KB page of CHR-ROM as a nametable
| |
| $E0-$FF: Use the NES's internal nametables (even values for A, odd values for B)
| |
| '''Note:''' On mapper 210, this register has no effect.
| |
| | |
| === Nametable Select 4 ($D800-$DFFF) w ===
| |
| 7 bit 0
| |
| ---- ----
| |
| NNNN NNNN
| |
| |||| ||||
| |
| ++++-++++- Select nametable at $2C00:
| |
| $00-$DF: Use a 1KB page of CHR-ROM as a nametable
| |
| $E0-$FF: Use the NES's internal nametables (even values for A, odd values for B)
| |
| '''Note:''' On mapper 210, this register has no effect.
| |
