|
|
| (4 intermediate revisions by 4 users not shown) |
| Line 1: |
Line 1: |
| [[Category:ASIC mappers]][[Category:Mappers with cycle IRQs]]
| | #REDIRECT [[VRC2 and VRC4]] |
| The Konami VRC4 is an [[:Category:ASIC mappers|ASIC]] [[MMC|mapper]].
| |
| | |
| | |
| __TOC__
| |
| | |
| | |
| == Overview ==
| |
| * PRG ROM size: Up to 256 KiB
| |
| * PRG ROM bank size: 8 KiB at $A000, and $8000 OR $C000
| |
| * PRG RAM: none, 2 KiB, or 8 KiB
| |
| * CHR ROM size: Up to 512 KiB
| |
| * CHR bank size: 1 KiB
| |
| * Nametable [[mirroring]]: Controlled by mapper
| |
| * Subject to [[bus conflict]]s: No
| |
| | |
| The Konami VRC4 is almost identical to the [[VRC2|VRC2]], but with a bit more capabilities, such as the option to swap PRG at $C000 instead of $8000 and an IRQ counter.
| |
| | |
| See [[VRC4 pinout]] for chip pinout.
| |
| | |
| == Banks ==
| |
| * CPU $6000-$6FFF: optional 2 KiB PRG RAM bank (mirrored once), or
| |
| * CPU $6000-$7FFF: optional 8 KiB PRG RAM bank
| |
| * CPU $8000-$9FFF (or $C000-$DFFF): 8 KiB switchable PRG ROM bank
| |
| * CPU $A000-$BFFF: 8 KiB switchable PRG ROM bank
| |
| * CPU $C000-$DFFF (or $8000-$9FFF): 8 KiB PRG ROM bank, fixed to the second-last bank
| |
| * CPU $E000-$FFFF: 8 KiB PRG ROM bank, fixed to the last bank
| |
| * PPU $0000-$03FF: 1 KiB switchable CHR bank
| |
| * PPU $0400-$07FF: 1 KiB switchable CHR bank
| |
| * PPU $0800-$0BFF: 1 KiB switchable CHR bank
| |
| * PPU $0C00-$0FFF: 1 KiB switchable CHR bank
| |
| * PPU $1000-$13FF: 1 KiB switchable CHR bank
| |
| * PPU $1400-$17FF: 1 KiB switchable CHR bank
| |
| * PPU $1800-$1BFF: 1 KiB switchable CHR bank
| |
| * PPU $1C00-$1FFF: 1 KiB switchable CHR bank
| |
| | |
| == Revisions ==
| |
| | |
| This mapper has been used with several board revisions, each of which uses different address lines.
| |
| All boards use A15-A12 the same way, along with two lines from A7-A0.
| |
| Here is a listing of known revisions, which address lines are used, and which [[iNES]] mapper number is used to represent it:
| |
| | |
| variant lines registers iNES Mapper Number
| |
| ----------------------------------------------------------------------
| |
| VRC4a A1, A2 $x000, $x002, $x004, $x006 [[INES Mapper 021|021]]
| |
| VRC4b A1, A0 $x000, $x002, $x001, $x003 025
| |
| VRC4c A6, A7 $x000, $x040, $x080, $x0C0 021
| |
| VRC4d A3, A2 $x000, $x008, $x004, $x00C 025
| |
| VRC4e A2, A3 $x000, $x004, $x008, $x00C 023
| |
| VRC4 #27 A0, A1 $x000, $x001, $x002, $x003 [[iNES Mapper 027|027]]
| |
| | |
| Some variants that use the same address lines use them in different ways. For example, VRC4d and VRC4e both use A2 and A3, however VRC4d has them reversed.
| |
| | |
| For historical reasons, some variants share a mapper number.
| |
| These may be detected with a hash of the PRG ROM, or the address lines used may be expressed in NES 2.0 with [[NES 2.0 submappers#VRC4|submappers]].
| |
| | |
| The RAM decoding circuit that's part of the VRC4 itself only decodes RAM from $6000-$6FFF. For the [http://bootgod.dyndns.org:7777/profile.php?id=1573 one game] with 8 KiB of RAM, an external [[PRG RAM circuit|circuit was added]].
| |
| | |
| == Registers ==
| |
| This page lists registers as they are in the VRC4a variant. For other variants, you can use the diagram above for determining which registers are used.
| |
| | |
| === PRG Swap Mode control ($9004, $9006) ===
| |
| | |
| 7 bit 0
| |
| ---------
| |
| .... ..M.
| |
| |
| |
| +-- Swap Mode
| |
| | |
| When 'M' is clear:
| |
| * the 8 KiB page at $8000 is controlled by the $800x register
| |
| * the 8 KiB page at $C000 is fixed to the second last 8 KiB in the ROM
| |
| | |
| When 'M' is set:
| |
| * the 8 KiB page at $8000 is fixed to the second last 8 KiB in the ROM
| |
| * the 8 KiB page at $C000 is controlled by the $800x register
| |
| | |
| | |
| === PRG Select 0 ($8000, $8002, $8004, $8006) ===
| |
| | |
| 7 bit 0
| |
| ---------
| |
| ...P PPPP
| |
| | ||||
| |
| +-++++- Select 8 KiB PRG bank at $8000 or $C000 depending on Swap Mode
| |
| | |
| === PRG Select 1 ($A000, $A002, $A004, $A006) ===
| |
| | |
| 7 bit 0
| |
| ---------
| |
| ...P PPPP
| |
| | ||||
| |
| +-++++- Select 8 KiB PRG bank at $A000
| |
| | |
| | |
| === Mirroring Control ($9000, $9002) ===
| |
| | |
| 7 bit 0
| |
| ---------
| |
| .... ..MM
| |
| ||
| |
| ++- [[Mirroring]] (0: vertical; 1: horizontal; 2: one-screen, lower bank; 3: one-screen, upper bank)
| |
| | |
| === CHR Select 0 ($B000, $B002) ===
| |
| | |
| $B000 $B002
| |
| 7 bit 0 7 bit 0
| |
| --------- ---------
| |
| .... LLLL ...H HHHH
| |
| |||| | ||||
| |
| |||| +-++++- High 5 bits of 1 KiB CHR bank at PPU $0000
| |
| ++++-------------- Low 4 bits
| |
| | |
| | |
| === CHR Select 1 ($B004, $B006) ===
| |
| | |
| $B004 $B006
| |
| 7 bit 0 7 bit 0
| |
| --------- ---------
| |
| .... LLLL ...H HHHH
| |
| |||| | ||||
| |
| |||| +-++++- High 5 bits of 1 KiB CHR bank at PPU $0400
| |
| ++++-------------- Low 4 bits
| |
| | |
| | |
| === CHR Select 2…7 ($C000-$EFFF) ===
| |
| The other six CHR bank selects continue the pattern:
| |
| {| class="wikitable"
| |
| ! colspan=2|Write to CPU address
| |
| |-
| |
| ! (low 4 bits) !! (high 5 bits) !! 1KB CHR bank affected
| |
| |-
| |
| | $C000 || $C002 || $0800-$0BFF
| |
| |-
| |
| | $C004 || $C006 || $0C00-$0FFF
| |
| |-
| |
| | $D000 || $D002 || $1000-$13FF
| |
| |-
| |
| | $D004 || $D006 || $1400-$17FF
| |
| |-
| |
| | $E000 || $E002 || $1800-$1BFF
| |
| |-
| |
| | $E004 || $E006 || $1C00-$1FFF
| |
| |}
| |
| | |
| === IRQ Control ($F00x) ===
| |
| $F000: IRQ Latch, low 4 bits
| |
| $F002: IRQ Latch, high 4 bits
| |
| $F004: IRQ Control
| |
| $F006: IRQ Acknowledge
| |
| | |
| Many VRC mappers use the same IRQ system. For details on IRQ operation, see [[VRC IRQ]]s.
| |
| | |
| == References ==
| |
| *[http://www.romhacking.net/documents/362/ NES Mapper List] by Disch
| |
| *[http://nesdev.org/konami-e.txt Konami Mapper] by goroh, translated by Sgt. Bowhack
| |
| *[http://nesdev.org/mappers.zip Comprehensive NES Mapper Document] by \Firebug\, information about mapper's initial state is inaccurate.
| |
| * The CHR registers really are 9 bits: http://forums.nesdev.org/viewtopic.php?t=8569
| |
